If your Site-to-Site VPN Internet Protocol security (IPsec/Phase 2) fails to establish a connection, then try the following steps to resolve the problem: Verify that the Site-to-Site VPN Phase 2 parameters are configured correctly on your customer gateway device. 241.



log. . .


9. ' ) and ( description contains 'IKE phase-1 negotiation is failed as responder, main mode. Aug 2, 2012 · Hi Manny, Thanks for the debug output! I believe we're making some progress and was able to establish IKE phase 1.

43/32 type IPv4_address protocol 0 port 0, received remote id: 192. You can carry out in-depth analysis on the IKE negotiation process of IPSec Tunnel Setup Failure.



The most common phase-2 failure is due to Proxy ID mismatch. 10.

. Mismatch in Proposal Phase 2 A.

A look at the ikemgr.
IPsec corresponds to Quick Mode or Phase 2.
That would be first thing I would check.

IKE phase-2 negotiation is failed as initiator, quick mode.

2/500, Local IKE-ID: 10.

10. The responder firewall is the receiver side of the VPN that receives the tunnel setup requests. 5.

x. local address NOT matched. 1 for Phase 1 and 1 for phase 2. shows the following errors:. . IKE Phase 1 or Phase 2 Settings are mismatched between the SonicWall and the Remote Peer.

It seems that the first router receives a request for IPSec Phase 2 negotiation but cannot find any entry for the peer in local configuration.

. Auth Algorithm Mismatch : Local (SHA1) --- Remote (SHA256) Debug Logs :.


24 2012-08-02 18:17:00: [rv120w][IKE] WARNING: schedular is already scheduled for SA creation for remote: "xx.


If the responder does not support commit-bit processing, the Communications Server IKE daemon does not wait for a connected notify message from the responder.

' ) and.